How to solve the discontinuity of MPC controller output？

Question

Jingchao Li 2020-8-6

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/576106-how-to-solve-the-discontinuity-of-mpc-controller-output

回答： Jingchao Li 2020-8-11

In simulink, I used the MPC toolbox to obtain the control value calculated by MPC with a sampling period of 0.05s.

In the following calculations, I need to derive the control variable. However, 0.05s is much smaller than the simulation step size, which leads to an infinite value for the derivative.

I tried to use low-pass filtering, but it still can't solve the problem well.

The MPC algorithm should calculate the control variables in the control horizon together, and then output them one by one. Is it possible to perform interpolation processing before the output of the MPC controller? Or is there any better way to solve this difficulty?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jingchao Li 2020-8-11

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/576106-how-to-solve-the-discontinuity-of-mpc-controller-output#answer_477835

When I use the discrete derivation module, the problem is solve

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Fangjun Jiang 2020-8-6

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/576106-how-to-solve-the-discontinuity-of-mpc-controller-output#answer_476122

Use a rate transition block or zero-order holder block to deal with different sample rate

4 个评论
显示 2更早的评论隐藏 2更早的评论

Jingchao Li 2020-8-10

编辑：Jingchao Li 2020-8-10

In the process of using the low-pass filter, I also encountered the same problem:

I added a low pass filter after the output of MPC.When it is not connected to other modules, the output becomes very smooth, but once connected to the controlled object, it cannot work.The system has no feedback, and the MPC output to the low-pass filter is exactly the same.

Jingchao Li 2020-8-11