A question about xPC Target stand alone
1 次查看(过去 30 天)
显示 更早的评论
Hi, I am a newer on xpc target stand alone, when i was refering to the matlab help about the xpc target stand alone. i met some question on which i was not sure whether i had got the correct understanding, and my understanding is as followed: when i have transfer the files i builded to the target computer, i should remove the boot disk which boots the kernel on the target computer and boot the target computer to the DOS system. in the dos system, i should: 1 save a copy of autoexec.bat; 2 edit the target computer file C:\autoexec.bat to include the following lines:cd C:\xpcfiles autoexec.
but my problem is: 1 and as i have not an experience on dos, could anybody give me favour on the dos command about the tow steps above. 2 i can not find the autoexec.bat file in the C:\ when i start my computer to xp system.
thanks very much!
采纳的回答
Ryan G
2013-1-4
You can do the copying/editing in windows before you boot in DOS. As long as the files are correct, it shouldn't matter where the editing took place.
The autoexec.bat file should be in a subdirectory from where you built your xPC on the original machine.
2 个评论
Ryan G
2013-1-7
Are you running through a virtual machine? Are you running DOS through windows? You have to make sure to boot the PC in DOS Only mode.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!