How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?

Question

MathWorks Support Team 2020-12-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/705648-how-to-enable-the-signal-visualization-blocks-in-the-qpsk-receiver-with-adalm-pluto-radio-example

编辑： MathWorks Support Team 2024-4-18

I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):

https://www.mathworks.com/help/comm/plutoradio/ug/qpsk-receiver-with-adalm-pluto-radio-1.html

However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.

I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?

请先登录，再回答此问题。

Answer 1

MathWorks Support Team 2024-4-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/705648-how-to-enable-the-signal-visualization-blocks-in-the-qpsk-receiver-with-adalm-pluto-radio-example#answer_587763

编辑：MathWorks Support Team 2021-12-22

In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.

Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.