SimPowerSystems Error "No Voltage/Current/Machine Block" with a Frequency matching Phasor Sim Frequency
96 次查看(过去 30 天)
显示 更早的评论
I have setup a simpowersystems 4 synchrounous machine model set at 60 Hz. When I try to run the model I receive an error message that says "There is no voltage source, current source, or machine block with a frequency matching the Phasor simulation frequency"
The setup is very similar to one of the synchronous machine example models in simulink. I have defined the system frequency in the mahcine as 60 Hz under teh parameters tab. Can anyone advise how to fix this issue.
0 个评论
回答(4 个)
shi wenbo
2019-1-9
This error is caused by some unconnected element existing in the model, like Line68-71 and BUS71 in the following picture.
hongyi Huang
2018-3-30
I recieved the same message when I just remove the breaker block and fault block from the PSS example model.Actually,I don't konw what is the Phosor simulation.It is my pleasure if any one can advise to me.
0 个评论
Henok Ayele Behabtu
2020-1-13
i solve such type of problem when i simulate wind turibne generator system grid intgration simulation case, the system is was running at fault condition(i connect the three phase fault ) but when disconnect the fault and run the simulink the error was happen.
when i remove the three phase fault from the simulink window it works, so dont run the simulation simple by disconnecting any device from your network.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!