How can I make a check box toggle when plot has different type?
显示 更早的评论
Here is what I have done so far.
[W,fs]=wavread(FileName); %this reads a wave file
[~,~,~,P]=spectrogram(W(:,end),tres,tres/2,fres,fs); %tres is time resolution %and fres is frequency resolution.
I=flipud(-log(P)); %here 'I' gives the spectrogram image in a matrix.
imshow(I,[]); %this line will display the image.
now my question is if I choose a pixel co-ordinate from the image matrix I how can I get its frequency?
采纳的回答
Paulo Silva
2011-6-4
ErrorFlag=1; %the code inside the while is executed
while(ErrorFlag)
try
%replace this line with your plot command
%if the plot command works without any error all worked fine so:
ErrorFlag=0; %change the flag to 0, the loop stops after this line
catch err
%if the error happens
cla %clear the axes
%axis is cleared so you can plot any type of plot
end
end
Answer edited, Jan Simon suggestion added.
The check box status remains the same.
If you want to send the error to the command line add this line after the catch:
LError=lasterror; disp(LError.message);
5 个评论
sadel
2011-6-4
sadel
2011-6-4
Jan
2011-6-4
@sadel: This can be done by a WHILE loop and a flag.
sadel
2011-6-4
Paulo Silva
2011-6-4
good and simple advice Jan :)
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Classical Control Design 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
