How to deploy the interface model to SD card of Xilinx Zynq ZCU102 kit so that it will run everytime I power up my hardware ?

2 次查看（过去 30 天）
丹 姚
丹 姚 2021-7-30
回答： JT Ferrara 2021-8-2
I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.
I followed the example "Getting Started with Targeting Zynq UltraScale+ MPSoC Platform".
But when doing the step "Run the software interface model on Zynq ZCU102 hardware", I found that the deployed software will not effective anymore after the hardware power off and on again. "Monitor & Tune" or "Bulid, deploy &start" buttons has no difference on this power off and on case.
So how can I do to make the ARM executable still be effective and run automatically after hardware power off and on?

请先登录，再回答此问题。

采纳的回答

JT Ferrara
JT Ferrara 2021-8-2

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Xilinx FPGA and SoC Devices 的更多信息

标签

产品


版本

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by