OFDM Transmit and Receive Using Xilinx RFSoC Device

5 次查看(过去 30 天)
Urgent help needed !!!!!!!
I am implementing the " OFDM Transmit and Receive Using Xilinx RFSoC Device" example in the ZCU111 RFSoC board.
I got stuck at the "Connect Hardware" section. Everything else completed. Even I have intalled necessary packages. The host computer detects the board but got stuck at the connect hardware step. Any immediate help would be highly appreciated. Thank you

采纳的回答

Chandra Adusumalli
Chandra Adusumalli 2021-8-10
Hi,
Have you done Hardware setup after installing the supportpackages? If you have not done already and please follw this link to do the hardware setup.
Please ensure that your hardware board address and address mentined in the Connect Hardware are same.
  1 个评论
Kefayet Ullah
Kefayet Ullah 2022-4-14
Hello Chandra,
Thank you for your quick response.
I am implementing the "Transmit and Receivea a Tone Using Xilinx RFSoC Device- Part I and II" from MATLAB/SIMULINK.
The model simulates perfectly. Infact, I reach the last stage of capturing the data. But, at the last stage of capturing the data at the ADC, I get the following error message:
"Unable to send message from 'Output Port 1' of block 'soc_rfsoc_datacapture_sw?IODataSource_Stream/Variant/SIM/Source_Variant/From_Constant/HWSW_Message_Send/Message_Send' because the output port is blocked. 2 messages were dropped during this simulation. To prevent messages from being dropped, increase the capacity of message storage connceted to this output port".
I am using the Xilinx ZCU111 evaluation board and MATLAB R2021b.
Any help and suggestions would be highly appreciated.
Thank you.

请先登录,再进行评论。

更多回答(0 个)

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by