Feeds
提问
Problems getting Master Transfer Block to function
I would welcome a pointer to some clearer documentation for the c28x SPI Master Transfer block in provided for TI MCU for use in...
3 years 前 | 1 个回答 | 0
1
个回答提问
SPI interface timing with deasserts
I'm looking for a way to read data from a Si8380S-IU chip from a TI F2337xD based processor. The Simulink examples for Master T...
3 years 前 | 0 个回答 | 0
0
个回答提问
Problem with external mode and model running on target hardware
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for mod...
3 years 前 | 1 个回答 | 0
1
个回答已回答
How to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
How to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
3 years 前 | 0
提问
Errors when examining CAN log output in Mathworks
I'm getting an error "Reference to non-existent field 'x_440V_Tripped' when attempting to load a CAN log file from a simulation ...
3 years 前 | 1 个回答 | 0
1
个回答提问
Ordering of CAN signal ports, when CAN Pack/Unpack is using "CANdb specified signals"
Regardless of the order in the CANdb file or the bit order assigned to signals, CAN unpack will show its outputs in alphabetical...
3 years 前 | 1 个回答 | 0
1
个回答已回答
Unclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
Unclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
3 years 前 | 0
| 已接受
提问
Unclear error message for Swicth-Case Action on model update
The error message "The action port on subsystem '......../Chip1_WriteBytes1' can only be connected to an If or Switch-Case and m...
3 years 前 | 1 个回答 | 0
