Feeds
提问
How do I perform PID controller from error by using matlab script?
I want to change the PID that is shown in this figure to matlab script I am tring to use PID=Kp*ev + Ki * integral(ev)+ Kd ...
5 years 前 | 0 个回答 | 0
0
个回答已回答
Error while importing the excel file into signal builder
I have the same problem on 2016a. did you get a solution?
Error while importing the excel file into signal builder
I have the same problem on 2016a. did you get a solution?
8 years 前 | 0
提问
How to select some element from matrix by simulink?
I want to get all element except -1 By Simulink For example: u2 = [46.15 ; -22.5 ; -1 ; ...
9 years 前 | 0 个回答 | 0
0
个回答提问
How to find the index of the first non-zero element in a 2-D array in simulink?
I want to find the index of the first non-zero element in a 2-D array in simulink, just like the way that 'find' command in ...
9 years 前 | 0 个回答 | 1
0
个回答提问
How to save video and images from usb webcam in Raspberry Pi by simulink?
I had connected the usb webcam to Raspberry Pi. I loaded the Simulink model that mention below onto Raspberry Pi board from the...
9 years 前 | 0 个回答 | 1
0
个回答提问
How to execute the Simulink model from Raspberry Pi?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...
9 years 前 | 0 个回答 | 0
0
个回答提问
How to start Simulink model on Raspberry Pi automatically on startup?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...
9 years 前 | 1 个回答 | 0
1
个回答提问
How to do Simulink model run in Raspberry Pi after power on (booting) as standalone ?
I build a Simulink model to control Dc motor, load into the board, stop Simulink model and plug out the power and Ethernet cable...
9 years 前 | 0 个回答 | 0
