信号监控和参数调节
配置主机和目标硬件之间的通信。Simulink® 模型会作为 C 代码部署在硬件上。
您可以针对 STM32 处理器生成优化代码以用于实时和中断驱动的代码执行，并使用 Embedded Coder® 执行实时信号监控、参数调节和处理器在环 (PIL) 测试。
主题
- Serial Configuration for Monitor & Tune and PIL for STM32 Processor-Based Boards
Configure your model to run in Monitor & Tune (External mode) and PIL for STM32 Processor-Based Boards.
- SoC Blockset Task Profiling
Use the SoC Blockset™ profiler to measure tasks on the STM processor.
- Use SoC Blockset Pass-Through Block Simulation
Use the SoC Blockset block pass through to add simulation to STM blocks.
- STM32CubeMX based PIL Execution at the Command Line Using MATLAB Coder
PIL Execution at Command Line for STM32CubeMX.
- STMCubeMX Based PIL Execution Using the MATLAB Coder App
PIL Execution with app.
- STM32CubeMX Configuration for Voltage Mode Control
Instructions for STM32CubeMX configuration.
- 在 STM32CubeIDE 中调试 Simulink 生成代码
将 Simulink 生成代码与 STM32CubeIDE 集成。
精选示例
Signal Monitoring and Parameter Tuning of Generated PWM Output
Use PWM Output block in a Simulink® model to generate PWM signals using Embedded Coder® Support Package for STMicroelectronics® STM32 Processors.
Signal Monitoring and Parameter Tuning Over XCP-based CAN Interface Using STM32 Processors
Monitor signals and tune parameters of a Simulink® model on STMicroelectronics® STM32 processor based board using XCP-based CAN Interface.
使用基于 STMicroelectronics STM32 处理器的板进行监控和调节
此示例说明如何使用 Embedded Coder® Support Package for STMicroelectronics® STM32 Processors 在基于 STM32 处理器的板上监控和调节仿真。
Getting Started with Hardware Profiling
Demonstrates how to perform real-time execution profiling of algorithms using the Embedded Coder® Support Package for STMicroelectronics® STM32 Processors. It covers two primary profiling methods:
MAT-file Logging on SD Card for STMicroelectronics STM32 Processors
Perform MAT-file logging using Simulink model on a Micro SD card mounted on an STMicroelectronics STM32 Discovery board.
