Installation Setup and Configuration

Install hardware support, update firmware, configure hardware connection

The Hardware Setup screen provides step-by-step instructions to install and configure Simulink^® Support Package for Raspberry Pi^® Hardware.
Learn how to establish communication between host computer and your Raspberry Pi hardware.

Functions

raspberrypi Get host name, user name, password, and build directory

listAudioDevices List available ALSA audio devices

ARM^® Cortex^®-A processors supported by Raspberry Pi boards.

Install support for Raspberry Pi hardware.

This section describes the workflow for downloading the core and optional application-based libraries and packages.

Run Simulink models on Raspberry Pi without providing a password.

Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.

Use the instructions in this section to enable the secondary I2C bus interface on your Raspberry Pi hardware board.

Use the instructions in this section to enable the secondary SPI bus interface on your Raspberry Pi hardware board.

Configure the network settings of your Raspberry Pi hardware.

You can use any of these methods to know the IP address of your Raspberry Pi hardware.

When Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.

Open a serial command-line session with Raspberry Pi hardware.

Set up Raspberry Pi hardware as a Linux^® desktop or terminal.

This example shows you how to run Linux® shell commands on your Raspberry Pi® hardware.

Extend Linux partition on the SD card for Raspbian Linux image.

This section describes about the model configuration parameters.

Include additional capabilities for code generation.

Configure, connect to, and control Raspberry Pi hardware in Simulink Online™.

Take steps to secure your Raspberry Pi in Simulink Online.