应用
在不同行业和应用中使用状态机
查看说明如何为特定行业和应用的决策逻辑进行建模和仿真的示例。
主题
监督逻辑
- 对发射中止系统进行建模
对轨道飞行器的发射中止系统进行建模。 - Implement an Automatic Transmission Gear System That Controls Transient Signals
Use debouncing logic to filter out transient signals that do not represent a true change of state. - Developing the Apollo Lunar Module Digital Autopilot (Simulink)
"Working on the design of the Lunar Module digital autopilot was the highlight of my career as an engineer. - Model a Wind Turbine Supervisory Control System
Model a safety control system for a wind turbine. - Model a Car with Automatic Transmission
Use a Stateflow chart to model the automatic transmission of a car.
任务调度
- Schedule Operations in a Hydraulic Control System
This example shows how to implement mode-based execution and event-driven scheduling in a hydraulic landing gear control system by using Stateflow® to coordinate multiple Simulink® subsystems. - Implement Distributed Control Logic in a Flexible Manufacturing System
Use atomic subcharts, masks, and parameters to reuse logic in a model of a pick-and-place manufacturing system. - Implement PackML in an Automated Packaging System
Use Stateflow® charts to implement PackML states and interfaces.
故障检测、隔离和恢复
- Detect and Isolate Faults in an Aircraft Elevator Control System
Design a fault detection, isolation, and recovery (FDIR) application for a pair of aircraft elevators controlled by redundant actuators. - Model Fault-Tolerant Fuel Control System
Combine Stateflow and Simulink® to model hybrid systems. - Design Operating and Failure Mode Control Systems for a Drilling Rig
Model the controls and failure identification system for a drawworks in a drilling rig.
电池管理
- Model Battery Management System with Stateflow
Model a system to manage battery SOC, detect faults, and balance battery cells. - Model Battery Management with Custom Code
Use custom code to design a system for battery management.
能源管理
- Building Climate Control
Model a building climate control system with Stateflow.
通信网络应用
- Model an Ethernet Communication Network with CSMA/CD Protocol
Model a collection of computers that communicate through an Ethernet communication network. - Design Microcontroller Using the I2C Communication Protocol
Design, implement, and test a microcontroller driver using the I2C communication protocol. - Detect Valid Transmission Data by Using Frame Synchronization
Use vectors of complex data to find a fixed pattern in a signal from a communication system. - Build Low-Pass Filter by Using Fixed-Point Data
Model a low-pass Butterworth filter that uses fixed-point arithmetic.
