Memory Operations

Use memory blocks to perform memory specific operation

Memory operation blocks support all Texas Instruments^® C2000™ microcontrollers.

Blocks

Memory Allocate	Allocate memory for new variable
Memory Copy	Copy data from and to memory section
Register Read/Write	Read from or write to various bit fields of TI C2000 Registers (Since R2024a)

Model Settings

Model Configuration Parameters for Texas Instruments C2000 Processors

Model Configuration Parameters: Code Generation Optimization

Featured Examples

Serial Communication Using SCI Blocks

Use the SCI blocks to set up serial communication between the target hardware and your host computer for C2000™ Microcontroller Blockset.

Open Model

Field-Oriented Control of PMSM with Hall Sensor Using C2000 Processors

Implements the field-oriented control (FOC) technique to control the speed of a three-phase permanent magnet synchronous motor (PMSM). The FOC algorithm requires rotor position feedback, which is obtained by a Hall sensor. For details about FOC, see Field-Oriented Control (FOC) (Motor Control Blockset).

Open Model

Open-Loop Control of 3-Phase AC Motors Using C2000 Processors

Uses open-loop control (also known as scalar control or Volts/Hz control) to run a motor. This technique varies the stator voltage and frequency to control the rotor speed without using any feedback from the motor. You can use this technique to check the integrity of the hardware connections. A constant speed application of open-loop control uses a fixed-frequency motor power supply. An adjustable speed application of open-loop control needs a variable-frequency power supply to control the rotor speed. To ensure a constant stator magnetic flux, keep the supply voltage amplitude proportional to its frequency.

Open Model