基于 STM32H7xx 的板(单核)
配置和使用 ADC、DAC、CAN、编码器、I2C、I2S、MQTT、TCP、UDP 等外设
使用对基于 STM32H7xx 处理器的板(单核)可用的 ADC、FDCAN、DAC、编码器、I2C、MQTT、TCP、UDP 等外设创建 Simulink® 模型。您可以为基于 STM32H7xx 处理器的板(单核)准备模型,以将 STM32CubeMX 工程与 Simulink 结合使用来生成代码并将代码部署到硬件。使用模型配置参数配置 Simulink 模型以与支持的目标硬件对接。
模块
主题
- 使用 STM32CubeMX 和 Simulink 配置基于 STM32 处理器的板
配置基于 STM32 处理器的板以在 Simulink 中使用 STM32CubeMX 工程。
- 为基于 STM32 处理器的板配置 STM32CubeMX 中的以太网选项
STM32CubeMX 工程中的以太网配置。
- Set Up Scheduling Options for STM32 Processor-Based Boards
Setting up scheduling options for STM32 processor based boards.
- Use SoC Blockset Pass-Through Block Simulation
Use the SoC Blockset™ block pass through to add simulation to STM blocks.
- Using CORDIC Co-Processor Block with DMA in STMicroelectronics STM32 Processor Based Boards
This example shows how to use and generate code for a CORDIC block in a Simulink® model for STMicroelectronics® NUCLEO-G431RB board to calculate SINE and COSINE values for given values of theta by using DMA.
- Introduction to MQTT
Basics of the MQTT messaging protocol.